<?xml version="1.0" encoding="UTF-8"?> <!DOCTYPE pkgmetadata SYSTEM "http://www.gentoo.org/dtd/metadata.dtd"> <pkgmetadata> <maintainer> <email>leio@gentoo.org</email> </maintainer> <maintainer> <email>idl0r@gentoo.org</email> <name>Christian Ruppert</name> </maintainer> <maintainer> <email>peter@stuge.se</email> <description>Please CC on all bugs</description> </maintainer> <use> <flag name="atahpt">Highpoint (HPT) ATA/RAID controller support</flag> <flag name="bitbang_spi">Bitbanging SPI infrastructure</flag> <flag name="buspirate_spi">Enable Bus Pirate SPI programmer</flag> <flag name="dediprog">Dediprog SF100 support</flag> <flag name="drkaiser">Enable Dr. Kaiser programmer</flag> <flag name="dummy">Enable dummy tracing</flag> <flag name="ft2232_spi">Enable ftdi programmer, flashing through FTDI/SPI USB interface</flag> <flag name="gfxnvidia">Enable NVIDIA programmer</flag> <flag name="internal">Enable internal/onboard support</flag> <flag name="nic3com">Enable 3Com NIC programmer</flag> <flag name="nicintel">Support for Intel NICs</flag> <flag name="nicintel_spi">Support for SPI on Intel NICs</flag> <flag name="nicnatsemi">Support for National Semiconductor NICs</flag> <flag name="nicrealtek">Support for Realtek NICs</flag> <flag name="ogp_spi">Enable support for OGP (Open Graphics Project) SPI flashing</flag> <flag name="rayer_spi">RayeR SPIPGM hardware support</flag> <flag name="satasii">Enable programmer for SiI SATA controllers</flag> <flag name="satamv">Enable programmer for Marvell SATA controllers</flag> <flag name="serprog">Enable Serial Flasher programmer</flag> <flag name="wiki">Enable wiki informations, like supported devices etc.</flag> </use> <longdescription lang="en"> flashrom is a utility for identifying, reading, writing, verifying and erasing flash chips. It is designed to flash BIOS/EFI/coreboot/firmware/optionROM images on mainboards, network/graphics/storage controller cards, and various programmer devices. * Supports more than 261 flash chips, 152 chipsets, 259 mainboards, 43 PCI devices, 5 USB devices and various parallel/serial port-based programmers. * Supports parallel, LPC, FWH and SPI flash interfaces and various chip packages (DIP32, PLCC32, DIP8, SO8/SOIC8, TSOP32, TSOP40, TSOP48, and more) * No physical access needed, root access is sufficient. * No bootable floppy disk, bootable CD-ROM or other media needed. * No keyboard or monitor needed. Simply reflash remotely via SSH. * No instant reboot needed. Reflash your chip in a running system, verify it, be happy. The new firmware will be present next time you boot. * Crossflashing and hotflashing is possible as long as the flash chips are electrically and logically compatible (same protocol). Great for recovery. * Scriptability. Reflash a whole pool of identical machines at the same time from the command line. It is recommended to check flashrom output and error codes. * Speed. flashrom is often much faster than most vendor flash tools. * Portability. Supports DOS, Linux, FreeBSD, NetBSD, OpenBSD, DragonFly BSD, Solaris, Mac OS X, and other Unix-like OSes. Partial Windows support is available (full support as patch). </longdescription> </pkgmetadata>